Automatic die-cutting machine debugging method
Release time:
2023-05-24
Source:
Automatic die-cutting machine debugging method
1, automatic die cutting machine turn on the power, check the equipment. Before not racking the mould test pressure for a few minutes before the machine, to ensure that the machine works properly! Die-cutting machine and even the machine punch products when the knife and mould must be set up straight, otherwise the punch out of the product is easy to lack of material, the automatic die-cutting machine machine template removed on the table on the workbench, put the mould on the adhesive tape horizontal straight on the template sticking.
2, automatic die-cutting machine installed on the template after the right or left screws tighten, rising pressure, so that the gap between the upper and lower templates must be higher than the mould plus the thickness of the PC board, the lower template with a PC board on the tape fixed in the mould below the part of the white paper sticky tape on the other side of the PC board did not stick the tape, the PC board in the next, the white paper in the middle; put on the duplicating paper slowly drop the pressure, the host point into the slow test pressure Until the white paper has the whole knife mould on the sub.
3, the print on the white paper is in order to hit the product when it is convenient to confirm the location of the debugging, the paper is placed under the PC board, with the positioning of the foam to do a good job of positioning. Place a good material test punch a mould, drain the waste, check the product, such as the product is found to be constantly or have a burr when taken out of the paper placed under the PC board, in the corresponding above the bad place to stick on the transparent adhesive tape.
If the product is found to be delaminated or overcut, it should be gently scraped with a razor blade at the corresponding defective place on the PC board. After the product trial adjustment is completed, set up the material to set the jump distance, etc., and punch out the first mould of the debugged product should find the quality control to confirm, and wait for the quality control to confirm the completion of the product before punching.
Related News
Follow Us
Contact Us
Add.: Tangxia Town, Dongguan City, Guangdong
Province, China
Tel: +86-0769-82109116
Mobile: +86-189-2949-9317
Mobile: +86-189-2925-7137
Email: sfzdhjx@163.com